I-7532

I-7532 is phased out and replaced by I-7532M-FD. It is a local CAN bridge used to establish a connection between two CAN bus system in a CAN network.The I-7532 stands by itself connecting adjacent wiring segments together as in the case of a CAN repeater (I-7531).Not just like I-7531, I-7532 have three more important features. First one, the transmission distance limitation of the CAN bus system on each side of I-7532 are independent, which means the total network distance can be extended.

Second one, when the CAN bus system on one side of I-7532 happpens some error (e.g. bit error), the system on other side can still work on correctly. Last one, the baud of two channel on I-7532 can be different for highly flexibility.

• Microprocessor inside with 72MHz
• 82C250 CAN transceiver
• 2500 VRMS photo coupler isolation on the CAN side
• 3KV galvanic isolation among the power supply and 2 CAN channels
• Support both CAN 2.0A and CAN 2.0B
• Fully compatible with the ISO 11898-2 standard
• Build-in jumper to select 120Ω terminal resistor
• Watchdog inside
• Up to 100 CAN nodes on each channel
• Transmission distance up to 1 km on each CAN port
• Removable terminal block, Mount easily on DIN-rail
• 768 frame buffer for each CAN channel
• The baud of each channel can be different for highly flexibility





Applications:

• Control System
• Building Automation
• Factory Automation
• Distributed data acquisition

• Quick Start
• User's Manual
• Quick Start Guide
• Hardware
• Data Sheet
• Wire Diagram
• Internal Diagram
• Firmware
• Software
• FCC Certification
• CE Certification