WISE-7153 is equipped with 16-channel dry contact digital inputs; each digital input channel supports counter input. WISE-7153 follows IEEE 802.3af-compliant (classification, Class 1) Power over Ethernet (PoE) specification. It allows receiving power from PoE enabled network by Ethernet pairs (Category 5 Ethernet cable). This feature provides greater flexibility and higher efficiency. With this design, it eliminates space, reduces the use of cables and eliminates the requirement for dedicated electrical outlets. Meanwhile, in case under a non-PoE environment, WISE-7153 will still be able to receive power from auxiliary power sources like AC adapters or battery, etc.
- Built-in Web Server for IF-THEN-ELSE rule setting
- Built-in IF-THEN-ELSE rule enigne for logic operation
- No more programming. Just click and get done!
- Support IO, Counter, Timer, Email operations
- Modbus/TCP Protocol for SCADA Software Seamless Integration
- IEEE 802.3af-compliant Power over Ethernet (PoE)
- 10/100 Base-TX Ethernet
- 2-way Isolation/ESD Protection
- DI Type: 16 Dry Contact
Building Automation, Factory Automation, Machine Automation, Remote Maintenance, Remote diagnosis and Testing Equipment, etc.
Dry Contact (Source)
On Voltage Level
Close to GND
Off Voltage Level
65535 (16 bits)
Max. Input Frequency
Min. Pulse Width
PoE Ethernet Port
10 / 100 Base-TX and Automatic MDI/MDI-X
2 Way Isolation
ESD (IEC 61000-4-2)
+/-4 kV Contact for each terminal and ±8 kV Air for random point
EFT (IEC 61000-4-4)
+/-2 kV for Power Line
Ethernet 10/100M Speed
Reserve Polarity Protection
Powered from terminal block
Yes, 12 ~ 48 VDC
Powered from PoE
Yes, IEEE 802.3af, Class1
Dimensions (W x H x D)
72 mm x 123 mm x 35 mm
DIN-Rail or Wall mounting
-25 °C ~ +75 °C
-30 °C ~ +80 °C
10 ~ 90% RH, non-condensing
Rule Configuration Website
Access Web server on WISE controllers to edit and upload logic rules through web browser.
36 IF-THEN-ELSE Logic Rules
3 IF conditions with AND or OR operators
3 THEN actions and 3 ELSE actions
48 Internal Registers
Hold temporary variables and read/write data via Modbus/TCP address.
Delay / Timing functions.
Send Email messages to pre-set Email receivers.
12 CGI Commands
Send pre-set CGI commands.
Set up THEN/ELSE action groups.
8 P2P remote modules
Set up the connection information for the remote WISE modules.
Real time control and monitoring I/O channels and system status of controllers via SCADA software.
ON, OFF, ON to OFF, OFF to ON, Change
=, >, <, ≥, ≤ (value)
=, >, <, ≥, ≤ (value), Change
Timeout, Not Timeout
DI, AI, DI counter, DO counter, IR
THEN / ELSE Actions
Change the value
DO(On/Off), AO, IR