PIO-D48

*** This product has been phased out and replaced by PIO-D48U ***

The PIO-D48 provides 48 TTL digital I/O lines. The PIO-D48 consists of six 8-bit bi-directional ports. The 8-bit ports are named port A (PA), port B (PB), and port C (PC). Port C can be split into 2 nibble-wide(4-bit) ports. All ports are configured as inputs upon power-up or reset. The PIO-D48 has one D-Sub connector and one 50-pin flat cable connector. Each header can be connected to a 50-pin flat cable. The flat cable can be connected to the ADP-37/PCI or ADP-50/PCI adapter. The adapter can be fixed on the chassis. It can be installed in a 5 V PCI bus and can support true "Plug & Play".

• PCI Bus
• Up to 48 channels of digital I/O
• All I/O lines buffered on the board
• Eight-bit groups independently selectable for I/O on each 24-bit port
• Input/Output programmable I/O ports under software control
• SMD, short card
• Connects directly to DB-24P, DB-24R, DB-24PR, DB-24PD,
  DB-24RD, DB-24PRD, DB-16P8R, DB-24POR, DB-24SSR, DB-24C
  or any OPTO-22 compatible daughter boards
• One 32-bit programmable internal timer
• One 16-bit event counter
• Interrupt source: 4 channels
• Pull-up or pull-down resistors on I/O lines
• Emulate two industrial-standard 8255 mode 0
• Buffer output for higher driving capability
• One D-Sub connector, one 50-pin flat cable connector
• Automatically detected by Windows 95/98/NT
• No base address or IRQ switches to set
• DIO response time is about 0.77 us (1.3 MHz max.)
• Software:

  • Toolkit for DOS

  • Toolkit for Windows 95/98
  • Toolkit for Windows NT
  • Toolkit for Windows 2000/XP
  • LabVIEW toolkit for Windows

  • Toolkit for OCX 95/98

  • Toolkit for OCX NT
  • Toolkit for OCX 2000/XP
  • Driver for LINUX
  • Driver for DasyLab
  • Toolkit for OCX 95/98
  • Toolkit for OCX NT
  • Toolkit for OCX 2000/XP
  • Driver for LINUX
  • Driver for DasyLab

• User's Manual
• Cut Sheet
• UniDAQ Software
• Cut Sheet
•