PCI BUS 48-Bit OPTO-22 Compatible DIO Board

PIO-D48

PCI BUS 48-Bit OPTO-22 Compatible DIO Board

Features

*** This product has been phased out and replaced by PIO-D48U ***

The PIO-D48 provides 48 TTL digital I/O lines. The PIO-D48 consists of six 8-bit bi-directional ports. The 8-bit ports are named port A (PA), port B (PB), and port C (PC). Port C can be split into 2 nibble-wide(4-bit) ports. All ports are configured as inputs upon power-up or reset. The PIO-D48 has one D-Sub connector and one 50-pin flat cable connector. Each header can be connected to a 50-pin flat cable. The flat cable can be connected to the ADP-37/PCI or ADP-50/PCI adapter. The adapter can be fixed on the chassis. It can be installed in a 5 V PCI bus and can support true "Plug & Play".
  • PCI Bus
  • Up to 48 channels of digital I/O
  • All I/O lines buffered on the board
  • Eight-bit groups independently selectable for I/O on each 24-bit port
  • Input/Output programmable I/O ports under software control
  • SMD, short card
  • Connects directly to DB-24P, DB-24R, DB-24PR, DB-24PD,
    DB-24RD, DB-24PRD, DB-16P8R, DB-24POR, DB-24SSR, DB-24C
    or any OPTO-22 compatible daughter boards
  • One 32-bit programmable internal timer
  • One 16-bit event counter
  • Interrupt source: 4 channels
  • Pull-up or pull-down resistors on I/O lines
  • Emulate two industrial-standard 8255 mode 0
  • Buffer output for higher driving capability
  • One D-Sub connector, one 50-pin flat cable connector
  • Automatically detected by Windows 95/98/NT
  • No base address or IRQ switches to set
  • DIO response time is about 0.77 us (1.3 MHz max.)
  • Software:
    • Toolkit for DOS

    • Toolkit for Windows 95/98
    • Toolkit for Windows NT
    • Toolkit for Windows 2000/XP
    • LabVIEW toolkit for Windows
    • Toolkit for OCX 95/98

    • Toolkit for OCX NT
    • Toolkit for OCX 2000/XP
    • Driver for LINUX
    • Driver for DasyLab
    • Toolkit for OCX 95/98
    • Toolkit for OCX NT
    • Toolkit for OCX 2000/XP
    • Driver for LINUX
    • Driver for DasyLab

Specifications

  • All inputs are TTL compatible
  • Logic high voltage: 2.4V ( Min. )
  • Logic low voltage: 0.8V ( Max. )
  • All outputs are TTL compatible
  • Sink current: 64 mA ( Max. )
  • Source current: 32 mA ( Max. )
  • Power consumption: +5V @ 900mA
  • Pin Assignment CN1
  • General Environment:
    • Operating Temperature : 0° to 60°C
    • Storage Temperature : -20°C to 80°C
    • Humidity: 0 to 90 % non-condensing
    • Dimensions : 156mm x 105mm

Related Products


ICP DAS USA,Inc.