PIO-D144

The DIO-144 Provides 144 TTL digital I/O lines. The DIO-144 emulates 8255 mode 0 and has a increased output current of 15 mA (source) and 64 mA (sink), which allows it to control LEDs and relay. The DIO-144 consists of eighteen 8 bit bi-directional ports and 2 input lines for interrupt enable and interrupt. The 8 bit ports are named port A(PA), port B(PB), and port C(PC). Port C can be split into two four bit ports. All ports are configured as inputs upon power-up or reset. The DIO-144 uses 4 I/O addresses. The base address is selectable from 200 to 3FF hex. The interrupt signal can be connected to any of the interrupt levels, 2 through 7 .

• Double side SMT, short card , power saving
• Connect directly to DB-24P, DB-24R, DB-24PR, DB-24SSR, DB-24POR
  and other OPTO-22 compatible daughter board
• 144 I/O Lines
• Emulate 6 Industrial standard 8255 mode 0
• Programmable interrupt handling
• Five 50-pin falt cable connector & one 37-pin D-sub connector
• Output status readback
• Interrupt handling capability

• Quick Start
• Data Sheet
• User's Manual
• Software Manual
• Installation on Windows XP
• PIN Assignment
• UniDaQ Development Kit