The I-87018 has officially been phased out and will no longer be available. It has now been replaced by I-87018W.
I-87018/R has a serial bus (RS-485) communication interface with DCON protocol. It can be plugged into our WinCon, LinCon, I-8000 controllers and I-87K, RF-87K I/O expansion units. I-87018/R is a Thermocouple Input Module with 8 channels. I-87018/R is a serial cartridge based I/O module that offers the ultimate in cost effective flexibility.
+/- 15mV, +/- 50mV, +/- 100mV
+/- 500mV, +/- 1V, +/- 2.5V
-20mA ~ +20mA(Requires Optional External 125 Ohm Resistor)
Thermocouple(J, K, T, E. R. S, B, N, C, L, M, LDIN43710)
10 Samples/ sec (Total)
+/- 0.1% of FSR
+/- 0.5μV °C
+/- 25 μV/ °C
Common Mode Rejection
Normal Mode Rejection
Open Thermocouple Detection
-35V to +35V
Intra-module Isolation, Field to Logic
1 LED as Power/ Communication Indicator
16 LEDs as High/ Low Alarm Signals
Maximum : 1.1W
-25 to 75 °C
-30 to 75 °C
5 to 95% RH, non-condensing
30mm x 88mm x 115mm(W x L x H)
Note：We recommend to choose I-87018Z for accurate thermocouple measurement.