I-7540DM-MTCP

• 80186-80 Embedded CPU, or compatible
• Ethernet Protocols, TCP,UDP,IP,ICMP,ARP
• COM driver support interrupt & 1K QUEUE Input & Output buffer
• Provide 200 CAN frames buffer in CAN to Modbus Mode
• NXP 82C 250 CAN Transceiver
• Support both CAN specification 2.0A and 2.0B
• Max transmission speed up to 1M bps for CAN and 115.2kbps for RS-232 & RS-485
• Max transmission distance of CAN over 1000m (follow CAN specification)
• 7-segment LED display to Module IP, RS-232 baud rate, CAN configuration…
• CAN Error/Tx/Rx LED indicator
• Software configurable CAN and RS-232 communication parameters
• Firmware updated from COM1 or Ethernet port
• Support Web Configuration
• Support maximum 24 Ethernet clients connection
• Support function code 0x03/0x04/0x10 of Modbus TCP/RTU command for reading and writing CAN message
• Provide the transparent communication between the CAN devices via Ethernet
• Support 30 specific CAN IDs in the Modbus TCP/RTU mode

Introduction

The I-7540D-MTCP is helpful for data exchanging between the Modbus devices and CAN devices. I-7540D-MTCP is a Modbus TCP server and acts as slave device in Modbus RTU network. It supports four communication modes: Modbus TCP, Modbus RTU, CAN-Ethernet Convert and Pair connection.

The major function of the I-7540D-MTCP is CAN to Modbus TCP/RTU gateway. It allows Modbus TCP/RTU device to communicate with CAN device on a CAN network. I-7540D-MTCP supports the function codes 0x03/0x04/0x10 of Modbus TCP/RTU for reading and writing CAN messages.

Furthermore, The device supports a transparent, protocol-independent transfer of the CAN messages, thus allowing its implementation into a wide range of possible applications. Furthermore, the CAN-Modbus Converter can be used with various higher layer CAN protocols (e.g. CANopen, DeviceNet or other proprietary protocols). The following figure shows the application architecture for CAN-Modbus Converter.

• Quick Start
• Data Sheet
• User's Manual